Interference may occur, resulting in incorrect data, if the computer is: Signals can be received only when the back of the computer is facing the sensor.The transmission distance may be shorter due to low temperature or low battery.Signals cannot be received if the distance between the sensor and the computer is too great.When adjusting the wireless sensor, note the following: The sensor was designed to receive signals within a maximum range of 70 cm, to reduce chance of interference. LCD screen may be distorted when viewed through polarized sunglass lenses.Dispose of used batteries according to local regulations.When cleaning the computer, bracket and sensor, do not use thinners, benzene, or alcohol.Tighten the dial on the Flex-Tight bracket by hand only.Pressing hard on other areas can result in malfunction or damage to the computer. When using the computer installed on the bracket, change the MODE by pressing on the three dotsīelow the screen.Doing so may result in a computer malfunction or damage. Do not leave the computer in direct sunlight for unnecessary or extended periods.If a child swallows a battery, consult a doctor immediately.Install the magnet, sensor, and bracket securely.Do not concentrate on the computer while riding.When attaching the bracket to the handlebarĥ Magnet 6 Sensor rubber pad 7 Bracket rubber pad 8 Nylon ties (x2)īefore using the computer, please thoroughly read this manual and keep it for future reference. * Install the sensor as close to the upper If the speed is not displayed, check that conditions * After installation, rotate the front wheel gently to check that the speed is displayed on theĬomputer. Stem if its back does not face the sensor as shown inĪttach the bracket to the stem or handlebarĬaution: Round off the cut edge of the bracket band to prevent injury. * The computer may not function appropriately on some (Option)Ĭaution: Make sure that the back of the computer faces the sensor. Stem, bracket can be mounted using the Bracket Holder and nylon ties. The clearance between the sensor surface and the magnet must not exceed 5 mm. The magnet must pass through the sensor zone. The back of the computer must face the sensor. ![]() ![]() The distance between the computer and the sensor must not exceed the transmission range of 70 cm.
0 Comments
Leave a Reply. |